CLS control display on the handlebar.
Left heated grip and temperature sensor on heated grip cable.
Removed the throttle grip sleeve and ground it down on the grinder so that the throttle grip fits onto the throttle grip sleeve.
Throttle grip sleeve installed and re-sanded with coarse sandpaper (60 or 80 grit).
Two copper sealing rings as spacers for the right handlebar weight so that the handlebar weight does not jam the throttle grip.
Heater handle connector on the right.
Cables are routed under the tank. Make sure that the cables are covered by the tank and that none of the cables obstruct the guide for the tank retaining screw.
CLS EVO Plus control in the left, small, front side panel.
CLS EVO Plus control.
Oil tank with aluminium holder under the seat.
Tank ventilation with hose connector in cable clip in the rear.
Oil line in black braided hose at swingarm pivot.
Oil line under the swingarm at the front right.
Oil line under the front left swingarm.
Oil line on the inside of the swingarm.
Nozzle on the outer flank of the sprocket.